Description
2008 Ford F250/350 6" 4WD 4 Link Kit |
2008 and / or current year model OEM Factory Chassis Applications are subject to change without notice.Special caution should be taken when installing on late model applications.RCD can not and will not be responsible for changes mid year by the OEMs and or improper or improvised installation. |
* Rear ride height listed is approximate and may vary depending on vehicle model.RCD supplies a 4.25" block that replaces the factory unit.This block is a direct replacement unit with the factory style bump-stop wing cast into it.RCD does not, nor does it recommend stacking blocks. Some vehicles are equipped with different size factory blocks and may require additional lift.Some models may require different u-bolts based upon leaf spring pack configuration. |
Stock Drive-shafts are retained.Vehicles equipped with a 2-piece rear driveline may require #20-68747 Carrier Bearing Drop Down Bracket (optional). |
Requires Wheels with a Maximum of 4 5/8" of Backspacing. |
System clears 36" x 12.50" tires.Minor fender / bumper trimming may be required.Actual trimming will depend on actual wheel / tire width, offset, actual tire diameters, etc. |
Standard Front End Disassembly Tools are required for Installation. |
System requires 4 wheel re-alignment following installation. |
Speedometer recalibration is required if larger tires are installed (larger than 10% over factory units). |
Factory Steering Stabilizer is retained. |
System Features (4) Zinc Plated Bilstein 5100 Series Performance Mono-tube Shock Absorbers. |
Reviews
There are no reviews yet.